• Home
  • Lucinda Hanging Instructions

Lucinda Hanging Instructions


  1. Tools you will need, Phillips head screw driver, ¼” Drill Bit, Level or tape measure.
  2. Take apart the four stand-offs which are attached to the packaging.
  3. Install stand-offs in the bottom two holes of your plaque. Make sure rubber washers are on each side.
  4. Determine your mounting surface:
    • Wood surface – You will need 2 Wood Screws.
    • Drywall surface – You will need 2 Plastic Wall Anchors w/2 screws (Provided)
    • Concrete surface – You will need 2 Plastic Wall Anchors w/2 screws (Provided)
  5. Drill the two top holes using the appropriate drill bit.
    • Wood surface – drill a pilot hole using proper drill bit going 1” deep.
    • Drywall surface – drill a pilot hole using proper drill bit going 1” deep. (Use screws provided for this procedure). After hole is drilled, place plastic wall anchor into hole
    • Concrete surface – drill a pilot hole using proper drill bit going 1” deep. (Use screws provided for this procedure). After hole is drilled, place plastic wall anchor into hole.
  6. Insert the screw through Stand-Off base. Tighten the screw into the pre-drilled pilot hole or plastic insert in the wall until securely fastened.
  7. Align the Lucinda Plaque top two holes over the stand-off bases. Screw Stand-Off caps through Lucinda plaque into Stand-Off bases and tighten by hand. No need to fix the bottom two stand-offs to wall.
  8. Stand back and admire your plaque beautifully hung on your wall!